ePermitting Electrical

NOTICE - ELECTRICAL CONTRACTORS:  DUE TO MANDATORY CONTINUING EDUCATION REQUIREMENTS THERE WILL BE NO ELECTRICAL INSPECTIONS ON FEBRUARY 6 & 7, 2014.  




Instructions for using the Online Permitting System

Job Details

Electrical

The first two question are yes/no questions, if the answer is yes check the box.

If the site is accessible without any special equipment required and if special equipment is required and is provided at the site check this box for Yes.

If upon completion of the permit you need a Certificate of Electrical Compliance check this box.

Complete the permit information with the numbers needed. If the number is zero then do not put anything in the field.

If the job is a burn out enter the number of meters involved, if any are overhead check the box to indicate Yes. If it is not a burnout leave both fields empty.

Enter the owners phone number so the inspector can contact the owner to gain access if you will not be on the site during the inspection.

Enter the subdivision and lot number and the associated building permit number if any. These are not required for rewires/burnouts. This is to help with the Certificate of Occupancy issuance for the overall project.

After completing all the applicable fields click next.

A confirmation screen will be loaded. Review the information that was submitted. If anything needs to be changed click the Previous button to back up to the point where changes are needed. If all information is correct click the Finish button.

The system will check the application after you have clicked "Finish". If there is a problem with the application, the problem will be displayed on the page and a link will be provided for you to go back and correct the problem.

Click the link below for Fee Payment Instructions.

Fee Payment